Проблемы инженерно-педагогического образования в Республике Беларусь: Recent submissions
Now showing items 341-360 of 546
-
Расчёт толщины вакуумно-плазменных покрытии
(БНТУ, 2009)Theoretical approaches to designing on the basis of applied MATLAB code of models of calculation of speed of sedimentation of unicomponent plasma streams are discussed.2021-09-22 -
Послойный анализ латунного покрытия латунированной проволоки методом лазерной искровой спектрометрии
(БНТУ, 2009)New method for layerwise spectral analysis of brass coating of steel wire is suggested. In this work double laser pulses are used to excite spectra of atoms brass termodiffusional coating. Using spectrometer LSS-I with a presented methodic one could perform layerwise analysis of thin metal coating with thickness of every layer approximately 0,015 mkm. Provided method reduce mistake ...2021-09-22 -
Особенности конструирования и формирования многослойных композиционных покрытий
(БНТУ, 2009)Иващенко, С. А. Особенности конструирования и формирования многослойных композиционных покрытий / С. А. Иващенко, О. В. Царук // Проблемы инженерно-педагогического образования в Республике Беларусь : материалы III международной научно-практической конференции, 23, 24 октября 2008 г., Минск, БНТУ / редкол.: Б. М. Хрусталев (гл. ред.) [и др.] ; под общ. ред. Б. М. Хрусталева. – ...2021-09-22 -
Увеличение адгезионной прочности соединения при термовулканизации резин на стали
(БНТУ, 2009)Some aspects of fastening of rubber mixes on steel are considered. The effective method of increasing of adhesive durability in combinations of sulfuric vul- canizate with steel due to additional introduction of sulfur in a zone of adhesive contact is developed.2021-09-22 -
Влияние направления ионного потока на изменение исходной шероховатости поверхности образцов из сплава Д16Т
(БНТУ, 2009)The modification of an initial surface roughness of exemplars from aluminium alloy Д16Т depending on an angle of attack of an ionic stream was investigated.2021-09-22 -
Характеристика методов формирования защитнодекоративных покрытий на изделиях из стекла
(БНТУ, 2009)Иващенко, С. А. Характеристика методов формирования защитнодекоративных покрытий на изделиях из стекла / С. А. Иващенко, В. М. Комаровская // Проблемы инженерно-педагогического образования в Республике Беларусь : материалы III международной научно-практической конференции, 23, 24 октября 2008 г., Минск, БНТУ / редкол.: Б. М. Хрусталев (гл. ред.) [и др.] ; под общ. ред. Б. М. ...2021-09-22 -
Исследование свойств новых текстильных материалов
(БНТУ, 2009)The research shows the analysis of molding properties of new textile matenaU manufactured in the Republic of Belarus. The materials which were tested by thr authors of the research are generally used for sewing industry. On the grounds of the results of the experiments and requirerhents to the textiles their potential for using as parts of footwear uppers was analyzed. The ...2021-09-22 -
Атомно-эмиссионный спектральный анализ многокомпонентных латунных сплавов методом лазерной искровой спектрометрии
(БНТУ, 2009)New method for atomic emission spectral analysis of cooper alloys in suggested. In this work double laser pulses are used to excite spectra of atoms in metallic alloy. Using spectrometer LSS-1 with a presented methodic one could receive rather high relative intensities of spectral lines, comparing to other methods, without increasing intensities of air and surround gases. Provided ...2021-09-22 -
Канавочный метод экспериментального определения коэффициента продольной усадки стружки
(БНТУ, 2009)Молочко, В. И. Канавочный метод экспериментального определения коэффициента продольной усадки стружки / В. И. Молочко // Проблемы инженерно-педагогического образования в Республике Беларусь : материалы III международной научно-практической конференции, 23, 24 октября 2008 г., Минск, БНТУ / редкол.: Б. М. Хрусталев (гл. ред.) [и др.] ; под общ. ред. Б. М. Хрусталева. – Минск : ...2021-09-22 -
Обеспечение качества поверхности деталей с вакуумно-плазменными покрытиями
(БНТУ, 2009)The influence of basis surface conditions and a droplet component of a condensed plasma stream on a quality of a surface of formed metal-silicon-nitrogen coverings is researched. It is installed, that a character of changes of covering’s surface roughness from size of the accelerating potential and an arc current doesn’t depend on a covering material. At an estimation of a covering ...2021-09-22 -
Условия получения и пьезоэлектрические свойства материалов системы 0,2PB(NB2/3Zn1/3)03-0,8(PBZt 0,5Ti0,5)03, легированной галлием и ванадием
(БНТУ, 2009)Piezoelectric properties of ceramic materials of the 0,2Pb(Nb2/3Zni з)О3- 0,8(РЬ2го.5ТІо 5)О3 system are studied. The influence of the Ga +3, V+5 doping ions nn piezoelectric properties of ceramic samples of the PNZ-PZT system is investigated. It is shown that pretreatment of powder mixture allows to decrease the calcinations temperature on 150°C and to receive the ceramics with ...2021-09-22 -
Формирование и исследование свойств наноструктурных защитных покрытий на стеклах и металлах
(БНТУ, 2009)Transparent heat-resistant coatings of 10...30 nm thickness described by (Zr02)х(Y2Oз)у composition are formed on the surface of metals and glasses by thermolysis technique. Produced coatings possess high adhesive strength, high corrosive and abrasive resistance. Nanocrystalline formations are revealed on samples surface, with quan tity of these formations depending on basic ...2021-09-22 -
Использование отходов нефтеперерабатывающего производства в качестве разбавителя лакокрасочных композиций
(БНТУ, 2009)The urgency of the present research is caused by absence of without waste technologies of oil refining. Wastes of oil refining manufacture are one from polluter of environments (ground, reservoirs and air). Besides thus that share of components which could be taken and used repeatedly is irrevocably lost also. Questions of protection of an environment from pollution and rational ...2021-09-22 -
Аргоновый плазмотрон постоянного тока для реализации различных высокопроизводительных технологических процессов
(БНТУ, 2009)This article is devoted creation powerful plasmatron for various technological processes and carrying out of laboratory researches. Wide-ranging studies of the electric arc burning in a longitudinal argon stream in the metal cylindrical channel are with that end in view spent. The design procedure of generators of plasma streams - plasmatrons of direct current is developed by ...2021-09-22 -
Условия получения и диэлектрические свойства СВЧ материалов для малогабаритных антенн
(БНТУ, 2009)Dielectric properties of ceramic materials of the Zn2Ti04 - ТiО2 binary system are studied. The influence of the Sn+3, Sb+3, Bi+3 doping ions on dielectric proper ties of ceramic samples of the Zn2Ti04 - ТiО2 system is investigated. It is found that the SHF materials with e<30 and tg6 of about 0.0001 can be prepared by modi fying the Zn2Ti04 - Ti02 ceramics. It is shown that the ...2021-09-22 -
Анализ усталостных изломов валов, восстановленных наплавкой
(БНТУ, 2009)Вигерина, Т. В. Анализ усталостных изломов валов, восстановленных наплавкой / Т. В. Вигерина // Проблемы инженерно-педагогического образования в Республике Беларусь : материалы III международной научно-практической конференции, 23, 24 октября 2008 г., Минск, БНТУ / редкол.: Б. М. Хрусталев (гл. ред.) [и др.] ; под общ. ред. Б. М. Хрусталева. – Минск : БНТУ, 2009. – С. 291-294.2021-09-22 -
Исследование пьезоэлектрических материалов с низкой температурой спекания
(БНТУ, 2009)It is established, that the piezoceramic materials on the basis of 0,41PNN- 0,23PZ-0,36PT solid solutions can be received on liquid-phase sintering procedure M temperatures 960-1100°C. It is received, that introduction of micro additives leads to change of parameters of a crystal lattice and growth of temperature of phase transition. The perspectivity of use of 0,41 PNN-0,23PZ-0,36PT ...2021-09-22 -
Зависимость структуры цикла колебаний инструмента при вибрационном точении от способа задания амплитуды
(БНТУ, 2009)Данильчик, С. С. Зависимость структуры цикла колебаний инструмента при вибрационном точении от способа задания амплитуды / С. С. Данильчик, В. И. Молочко // Проблемы инженерно-педагогического образования в Республике Беларусь : материалы III международной научно-практической конференции, 23, 24 октября 2008 г., Минск, БНТУ / редкол.: Б. М. Хрусталев (гл. ред.) [и др.] ; под общ. ...2021-09-22 -
Разработка электронного учебника по теоретической механике на основе пакета Mathematica
(БНТУ, 2009)In the present paper the description of the electronic educational supply is represented, which is developed in the form of one of the divisions of the reference base of data of the computer system Mathematica. Its content composes theoretical materials on the basic (statics, kinematics, and dynamics) and specialized (theory of impact) divisions of theoretical mechanics, examples ...2021-09-22 -
Кинетика формирования наноструктуры при гидратационном твердении алюминиевой пудры
(БНТУ, 2009)Афанасьева, Н. А. Кинетика формирования наноструктуры при гидратационном твердении алюминиевой пудры / Н. А. Афанасьева, В. Е. Романенков // Проблемы инженерно-педагогического образования в Республике Беларусь : материалы III международной научно-практической конференции, 23, 24 октября 2008 г., Минск, БНТУ / редкол.: Б. М. Хрусталев (гл. ред.) [и др.] ; под общ. ред. Б. М. ...2021-09-22